January 27, 2008 3:13 PM

yea I have the same problem, but mine it in pieces. I'm trying to figure out a good mod for it. But with everythig I'm doing right now it has hit the back burners at the moment. I did here of a good mod to try, though I have not had the time to do testing on it. It's putting a back edge detector on it so it wont fall off the table while baking up. If your good with electronics and haking you might want to try to make a circuit for this. Just a though. GWJax

GWJax, To Hack and make mods on robots is a life style and comes natural and not by choice. If a robot has a screw to open it then it must be opened!

January 27, 2008 6:17 PM

RobosapienRevolution said: The back edge detector sounds good... mine fell off a table 3 times while going backwards. Thanks.

Keep us informed on your progress. If you need any help let me know. GWJax

GWJax, To Hack and make mods on robots is a life style and comes natural and not by choice. If a robot has a screw to open it then it must be opened!

January 28, 2008 6:18 PM

Let's hope not because that is how it finds the edge. I know another on for you. inside of his head put a bunch of small leds that flash like he is thinking about something. The top of the head is a see through purple plastic mainly to cut down on IR interfearance. You could also give him sterioscopic hearing instead of mono hearing. On the back of his neck is a little button that can be drilled out and install a LED that flashes when he makes a noise from the speaker. or some how give him a wagging tail that if you pull it he howels. or replace the on off switch with a push down switch on the button on the back hips so it's easeier to turn him on and off. Just some more thoughts. GWJax

GWJax, To Hack and make mods on robots is a life style and comes natural and not by choice. If a robot has a screw to open it then it must be opened!